Multiplexer Test; System - PASI Polares 32 User Manual

Multiplexer test

The multiplexer test allow the user to check the correct operation of the two internal
multiplexers in the system and any externally connected multiplexers. Simply select the
multiplexer to test and press the "Start Test" button. The test can last up to two minutes.
At the end of the test, a window will display the result.
NOTE: the electrode connector of the multiplexer to be tested must be closed with the
termination plug for the test to be performed correctly.
F 21:
IGURE MULTIPLEXER TEST

System

The System screen is used to obtain information about system versions, the update status
of the installed software (only if the PC has an Internet connection) and to configure
certain parameters of the Polares 32 programme.
The configurations that can be implemented are as follows.
42