Table of Contents
Advertisement
Errore. Per applicare Heading 1 al testo da visualizzare in questo punto, utilizzare la scheda
Electrical parameters
The fourth template display page shows the electrical parameters that will be used when
performing measurements. These parameters can be configured by the operator.
F
17: E
IGURE
LECTRICAL PARAMETERS FOR A TEMPLATE
The visible and configurable parameters on the page are listed below.
•
"Max. sigma [%]": defines the mean square deviation value as a percentage of the
measurement value, at which point the system will assume that the value obtained is
precise enough and will not perform any further repetitions of the measurement.
•
"Max. attempts": defines the maximum number of cycles to be performed for a
measurement; when this number of cycles is reached the measurement will still be
terminated, even if the Max. sigma value has not been reached.
•
"Frequency": value used for performing the measurement.
POLARES 32
Home.
.
31
Advertisement
Table of Contents
