Connecting The Am(Mw/Lw) Aerial; Connecting The Fm Aerial; Connecting To An External Source; Cd Digital Out Jack - Samsung MAX-KDZ150 Instruction Manual

Connecting the AM(MW/LW)
Aerial
GB
The AM(MW)/LW aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM(MW)/LW aerial connector terminals are located on the rear
of the system and are marked AM(MW)/LW.
To avoid noise interference, check that the loudspeaker wires
do not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.

Connecting the FM Aerial

How to connect a COAXIAL TYPE aerial.
Connect a 75 antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial sock-
et (75 ) marked FM on the rear of the system.
Follow the instructions given on Page 28 to tune into a radio sta-
tion, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the
rear of the system using a 75 coaxial cable (not supplied).
11

Connecting to an External Source

The auxiliary input can be used to take advantage of the
sound quality of your Mini Component System when listening
to other sources.
Examples: A television
A video disc player
A Hi-Fi stereo video cassette recorder
To connect the external source, the source must have an audio
output. In addition, you need an RCA connection cable.
1
Set the system to standby mode and disconnect it and the external
source from the main.
2
Connect the audio cable to the rear of the Mini Component System.
Connect the...
Red jack
White jack
For optimum sound quality, do not invert the right and left
channels.
3
Plug the system back into the main socket and press Standby/On to
switch it on.
4
Select the AUX source by pressing AUX.
Result: AUX is displayed.
5
Switch the external source on.

CD Digital Out Jack

This unit can output digital sound signals through this jack.
Use an optical cable to connect digital audio equipment.
(DAT deck, MD recorder, etc.).
Remove the dust cap (1) from the DIGITAL OUT jack. Then,
connect an optical cable plug to the DIGITAL OUT jack.
When the DIGITAL OUT jack is not being used
Attach the supplied dust cap.
To the connector marked...
R (right)
L (left)