Connecting The Video Out To Tv; Connecting The Fm And Am Antennas - Samsung HT-KD800 Instruction Manual

Connecting the Video Out to TV

Make sure that turn off and disconnect the plug from outlet before moving or installing the product.
In connecting to video, select one of following two methods that suits for TV and connect it.
Composite Video ............... Good Quality
METHOD 1
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
Scart ............... Better Quality
METHOD 2
If you television is equipped with an SCART input, connect an Scart Jack (not supplied)
from the AV OUT jack on the back panel of the system to the SCART IN jack on your
television.
For using the SCART cable
• If Scart is equipped for your TV, set RGB-COMPOSITE selector
of the center unit to RGB. You can get a better picture quality by
using Scart setting.
• If Scart (RGB Input) is not equipped for your TV,
set RGB-COMPOSITE selector to COMPOSITE.
13
FM antenna connection
1. Connect the FM antenna supplied to the
FM 75 COAXIAL terminal as a temporary
measure.
2. Slowly move the antenna wire around until
you find a location where reception is good,
RGB
then fasten it to a wall or other rigid surface.
COMPOSITE
RGB
Cooling Fan
COMPOSITE

Connecting the FM and AM Antennas

FM Antenna (supplied)
AM antenna connection
1. Connect the AM loop antenna supplied
to the AM and
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
AM Loop Antenna
(supplied)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
terminals.
14