Zenoah EX2600 Owner's Manual page 14

EX2600
6. Set up
(PS-EX2 only)
WARNING
Pay attention to the correct direction of the saw
chain.
3. Fit the chain tension adjuster nut into the lower hole
of the guide bar, then install the chain cover, and fasten
the mounting nut to finger tightness.
(2)
(1)
(1) Hole
(2) Moving direction
(3) Chain cover
4. Adjust the chain tension by turning the chain tension
adjuster screw until the tie straps just touch the bot-
tom side of the bar rail.
(1)
(b)
(a)
5. Tighten the mounting nut securely with the bar tip held
up (TORQUE: 8.9 - 11.7 N.m./90 - 120 kg-cm). Then
check the saw chain for smooth rotation and correct
tension while moving it by hand. If necessary, read-
just.
(1)
GB-14
01-EX2600_GB_cs5_二.indd 14
(3)
(1) Chain tension adjuster
screw
(a) Loosen
(b) Tighten
(1) Tighten
WARNING
It is very important to maintain the proper chain
tension. Rapid wear of the guide bar or the chain
coming off easily can be caused by improper ten-
sion. Especially when using a new chain, take good
care of it since it should expand when first used.
BALANCE UNIT
1. Put on harness and attach unit to harness.
2. Depending on the working posture, slide clamp up or
down until unit balances and the harness fits your
body.
17/04/14 18:09