Zenoah EX2600 Owner's Manual page 13

6. Set up
(LRT-EX only)
ATTACHING THE TRIMMING MECHANISM
(1) Tube
(2) Transmission
(3) Screw hole
(4) Screw
(5) Fastening bolt
1. Remove the screw screwed into the end of the trans-
mission.
2. Insert the end of the tube into the transmission.
3. Line up the hole on the end of the transmission into
which the screw is to be inserted with the screw hole
on the tube, and screw the screw firmly in.
4. Using a wrench, screw the bolt provided to fix the
transmission into place.
BALANCE UNIT
1. Put on harness and attach unit to harness.
2. Depending on the working posture, slide clamp up or
down until unit balances and the harness fits your
body.
01-EX2600_GB_cs5_二.indd 13
6. Set up
(PS-EX2 only)
ATTACHING THE PRUNING MECHANISM
(4)
(1)
(3)
(5)
(1) Tube
(3) Screw hole
(5) Bolt
1. Remove the bolt screwed into the end of the trans-
mission.
2. Insert the end of the tube into transmission.
3. Line up the hole on the end of the transmission into
which the bolt is to be inserted with the screw hole on
the tube, and screw the bolt firmly in.
4. Using a wrench, screw the bolt provided to fix the
mechanism into place.
A standard package contains the items as shown be-
low.
(1) Guide bar
(3) Transmission
(5) Chain tension adjuster screw
(7) Chain tension adjuster nut
Install the guide bar and the saw chain on the
transmission as follows.
WARNING
The saw chain has very sharp edges. Use protec-
tive gloves for safety.
1. Loosen a nut and remove the chain cover.
2. Mount the guide bar then fit the saw chain around the
guide bar and sprocket.
EX2600
(2)
(2) Transmission
(4) Fastening bolt
(2) Saw chain
(4) Sprocket
(6) Nut
(8) Chain cover
GB-13
17/04/14 18:09
G
B