Replacing The Fuse; Replacing The Headlight Bulb - Yamaha DT125R 2004 Owner's Manual

1D0-F8199-E2.qxd 20/9/04 11:32
2. If the battery will be stored for
more than two months, check it
at least once a month and fully
charge it if necessary.
3. Fully charge the battery before
installation.
4. After installation, make sure that
the battery leads are properly
connected to the battery termi-
nals.
CAUTION
Always keep the battery char-
ged. Storing a discharged bat-
tery can cause permanent bat-
tery damage.
To charge a sealed-type (MF)
battery, a special (constant-
voltage) battery charger is
required. Using a conventional
battery charger will damage
the battery. If you do not have
access to a sealed-type (MF)
battery charger, have a Yamaha
dealer charge your battery.
All manuals and user guides at all-guides.com
Página 55
PERIODIC MAINTENANCE AND MINOR REPAIR

Replacing the fuse

2
ECA10630
1. Fuse
2. Reserve fuse
The fuse holder is located beside the
battery case.
If the fuse is blown, replace it as
follows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuse:
15 A
EAUS1180
CAUTION
Do not use a fuse of a higher ampe-
rage rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
1
Replacing a headlight bulb
1. Couplers
6-24
3. Turn the key to "ON" and turn on
the electrical circuits to check if
the devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
ECA10640
EAU23910
1