Replacing The Turn Signal Light; Bulb; Supporting The Motorcycle; Front Wheel - Yamaha DT125R 2004 Owner's Manual

1D0-F8199-E2.qxd 20/9/04 11:32
CAUTION
Do not overtighten the screws,
otherwise the lens may break.
Replacing a turn signal light

bulb

1
1. Screw
2. Lens
3. Bulb
1. Remove the turn signal light lens
by removing the screw.
2. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
All manuals and user guides at all-guides.com
Página 57
PERIODIC MAINTENANCE AND MINOR REPAIR
ECA10680 4. Install the lens by installing the
screw.
CAUTION
Do not overtighten the screw,
otherwise the lens may break.
EAU24201

Supporting the motorcycle

Since this model is not equipped with
a centerstand, follow these precau-
tions when removing the front and
rear wheel or performing other main-
3
tenance requiring the motorcycle to
stand upright.
2
motorcycle is in a stable and level
position before starting any mainte-
nance. A strong wooden box can be
placed under the engine for added
stability.
To service the front wheel
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing
a jack under the frame in front of
the rear wheel.
ECA11190
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a
motorcycle stand is not available, by
EAU24350 placing a jack either under each side
of the frame in front of the rear wheel
or under each side of the swingarm.

Front wheel

Check that the
To remove the front wheel
1. Speedometer cable
2. Axle retainer nut (x4)
3. Wheel axle
6-26
2. Raise the front wheel off the
ground by using a motorcycle
stand.
1
3
EAU24360
EAU24640
2