ENG
Selecting the Sound Mode
Switching the Sound Off Temporarily
30
(depending on the model)
The "S.MODE" button displays/controls the processing and output
of the audio signal. When power is switched ON, the mode is
automatically preset to either "Dual-I" or "Stereo", depending on
the current transmission.
Type of broadcast
Regular broadcast
(Standard audio)
Regular +
NICAM Mono
NICAM
Stereo
NICAM Stereo
NICAM Dual-I/II
Regular broadcast
(Standard audio)
A2
Bilingual or Dual-I/II
Stereo
Stereo
➣
◆ If the receiving conditions deteriorate, listening will be
easier if the mode is set to the "Mono" position using the
S.MODE button.
◆ If the stereo signal is weak (or if intermittent Stereo-Mono)
and automatic switching occurs, then switch to the
"Mono" mode.
◆ When receiving mono sound in the AV mode, connect to
the "L" input jack on the panels. If the mono sound
comes out only from the left speaker, then press the
S.MODE button.
You can switch the sound off temporarily, for example you may
wish to answer the telephone.
1
Press the MUTE
Result:
The sound is switched off and "
2
When you wish to turn the sound back on at the same volume as
before, press the MUTE
buttons).
On-screen indication
Mono (Normal use)
Mono ↔ Mono
Nicam
Stereo ↔ Mono
Nicam
Dual-I → Dual-II → Mono
Nicam
Nicam (Normal)
Mono (Normal use)
Dual-I ↔ Dual-II
Stereo ↔ Mono
button.
" is displayed.
button again (or either of the volume
(Normal)
(Normal)
(Forced Mono)