Table of Contents
Advertisement
Plug & Play Feature
When the television is initially powered ON, three basic customer
settings proceed automatically and subsequently: setting the
language, channel and clock.
1
If the television is in Standby mode, press the POWER
the remote control.
Result:
The message PLUG & PLAY is displayed. It flickers for a
little while and then the LANGUAGE menu is automatically
displayed.
2
Move the joystick up or down to select required language. Press
the MENU
button to enter the language, and then the message
ANT. INPUT : CHECK is displayed.
➣
If any language is not selected on the LANGUAGE menu, the
LANGUAGE menu will be displayed about 30 seconds later.
3
Make sure that the antenna is connected to the TV. And move the
joystick left or right.
Result:
The AUTO STORE menu is displayed.
4
Select your country by moving the joystick left or right. To search
the channels, select the SEARCH by moving the joystick up or
down, and then move the joystick left or right (refer to "Storing the
Channels Automatically" on page 17). Press the MENU
skip.
Result:
The TIME menu is displayed.
5
Move the joystick left or right to move to the hour or minute. Set the
hour or minute by moving the joystick up or down (refer to "Setting
and Displaying the Current Time" on page 32).
6
When you have finished, press the MENU
Result:
The message ENJOY YOUR WATCHING is displayed,
and then the channel which has been stored will be
activated.
button on
button to
button.
PLUG & PLAY
LANGUAGE
ENGLISH
SELECT
ENTER
ANT. INPUT : CHECK
SELECT
EXIT
AUTO STORE
AREA
: AUSTRALIA
SEARCH : -/+
SELECT
ADJUST
EXIT
TIME
CLOCK
: -- : -- AM
TIMER
: OFF
SELECT
ADJUST
EXIT
ENJOY YOUR WATCHING
13
ENG
Advertisement
Table of Contents
