Table of Contents
Advertisement
Additional heater information
Humidifier tray
Your heater is fitted with an enamel humidifier
tray. To fill the tray, open the access panel as
shown below. Pour water into the tray, or in the
case of the 1005, pour water into the filler spout
built into the access panel.
309 / 559/ 561
Access
panel
Pull
Max.
fill line
1005
Humidifier tray
Max. fill line
Filler spout
If you notice water in the humidifier tray, but
you have not placed any in there do not be
alarmed, this is normal. This will be condensate
from the flue system—designed to drain into
the humidifier tray.
If you are using the humidifier tray, it will need
filling approximately once a day.
•
Do not fill the humidifier tray while the
heater is on, it will be very hot and could
cause burns—turn the heater off and wait at
least five minutes.
•
Do not operate the heater without the
humidifier tray in place.
10
Push
Access panel
Pull
Vertical louvre adjustment
When the heater is turned off the direction of
the warm air flow may be altered by carefully
inserting a screwdriver or similar tool and gently
bending the vertical louvres to the left or right.
The louvres are not designed to be adjusted
more than six times as they will weaken and
break.
Power failure
If a power failure occurs the unit will turn itself
off. After power has been restored the unit will
automatically turn on again—you may need to
reset the clock depending on the length of the
power cut.
If timer settings have been programmed the
system memory will retain the timer settings,
but the clock will stop at the time the power
goes off and will be slow by however long the
power has been off.
Preheat
Automatically functions in conjunction with the
timers. When a timer is selected, the heater
may operate anywhere within an hour prior
to the programmed on time. The preheat
function ensures the room reaches the desired
temperature by the programmed start time.
Advertisement
Table of Contents
