PLATINUM
Series User's Guide
TM
Level
Level
Level
2
3
4
VALy
PEAk
Stby
4. Reference Section: Initialization Mode (INIt)
Use Initialization Mode to set the following parameters and perform the following functions:
4.1
4.2
4.3
4.4
4.5
4.6
4.7
4.8
4.9
4.10
4.11
4.12
4.13
4.1
Input Configuration (INIt > INPt)
Select the Input parameter (INPt) to configure the input.
Navigate to the correct setting. Settings include the following:
•
t.C.
•
Rtd
•
tHRM - Thermistor Temperature Sensor
•
PRoC - Process Voltage or Current Input
Select the indicated setting.
4.1.1 Thermocouple Input Type (INIt > INPt > t.C.)
Select Thermocouple (t.C.) as the input type (factory default). Then specify a specific type of
thermocouple or the last selected type will be used.
Displays the lowest input reading since the VALy was last cleared
Displays the highest input reading since the PEAk was last cleared
Standby Mode, outputs, and Alarm conditions disabled, displays Stby
- Thermocouple Temperature Sensor (entry point)
- Resistance Temperature Detector (RTD)
Reference Section: Initialization Mode (INIt)
Notes
Omega Engineering | www.omega.com
22