Function In Configuration Mode - Omega MICROMEGA CN77000 series User Manual

Button

Function in Configuration Mode

MENU To enter the Configuration Mode, the user must first press MENU. Use this button to
advance/navigate to the next setting. The first menu to appear will be "ID Code", if enabled. The user
can navigate through all the top level menus by pressing MENU. Selecting an ID of 0000 will allow you
to bypass the ID Menu using the MENU button.
/MAX Press this button to scroll through "flashing" selections. When a numerical value is flashing, this button
will increase the active digit from "0" to "9". After "9" the display starts at "0" again. The most
significant digit may also show a "Ð" sign. In the Run Mode MAX causes the display to flash the PEAK -
press again to return to the PV value.
/MIN Press this button to go back to a previous Top Level Menu item.
Press this button twice to reset the controller to the Run Mode.
When a numerical value is flashing, this button will scroll through the digits from left to right digit
allowing the user to select the desired digit to modify. In the Run Mode, MIN causes the display to flash
the VALLEY - press again to return to the PV value.
ENTER Press this button to access the submenus from a Top Level Menu item. Also, press this button to store
a submenu selection or after entering a value Ñ the display will flash a "stored" message to confirm
your selection. To reset flashing PEAK or VALLEY press ENTER. In the Run Mode, press ENTER
twice to enable Standby Mode with flashing "
NOTE: Except for Setpoints and the Alarms, modifying any settings of the menu configuration will reset the
controller prior to resuming Run Mode.
O : C
PERATION ONFIGURATION
".
STBY
part
3
M
ODE
17