Figure 3-1 New Communications Module Installation - Siemens SITRANS F US Hardware Installation Instructions

4. Remove the four mounting screws and standoffs
5. Install the new standoffs supplied in the mounting kit in the vacant positions.
6. Place the Communications Module over the I/O Module and align connector J3 with P1 of
SITRANS F US Clamp-on Communications Module
Compact Hardware Installation Instructions, 2/2014, A5E32586525-AD
①
Flow Meter
②
I/O Module cover, cover screw,
standoff
③
Flow Meter Cover Latch
Figure 3-1 New Communications Module Installation
discard.
the I/O Module (figure 3-2).
F US Clamp-on Communications Module Installation
④
Power Connector location
⑤
I/O Module
⑥
I/O Module captive mounting screws
⑥
that secure the I/O Module
⑤
and
11