Siemens SITRANS F US Hardware Installation Instructions page 10

F US Clamp-on Communications Module Installation
Hazardous Voltage
May cause death or serious personal injury.
Disconnect power before working on this product.
NOTICE
Electrostatic Discharge, All Electronic Assemblies
Take precautions against static discharge when handling circuit boards. Semiconductor
devices must be protected from electrostatic discharge. A properly grounded conductive
wrist strap must be worn whenever a circuit board assembly is handled or touched.
Note
For proper installation, mounting, wiring, and menu configuration of the flow meter please
refer to the appropriate Operating Instructions manual.
New Communications Module Installation
This installation procedure is for flow meters with an I/O Module installed but no Modbus
Communications Module previously installed. Mounting kits are also required for this
installation.
1. Disconnect power to the unit.
2. Open the flow meter cover by releasing the side cover latch
3. Loosen the I/O Module cover captive screw
standoff.
10
WARNING
②
and remove the cover, screw and
SITRANS F US Clamp-on Communications Module
Compact Hardware Installation Instructions, 2/2014, A5E32586525-AD
③
.