Indications And Displays On The Transmitters - Sennheiser EK 100 G2 Operating Instructions Manual

Indications and displays on the transmitters

Operation and battery status indication
The red LED (LOW BAT/ON) provides information on the current operating
state of the transmitter:
Red LED lit up:
Red LED flashing:
In addition, the 4-step battery status display
information on the remaining battery/accupack BA 2015 capacity:
3 segments:
2 segments:
1 segment:
Battery icon flashing:
"MUTE" display
The "MUTE" display
muted (see: „Muting the transmitters" on page 23).
Modulation display
The level display for audio signal (AF) shows the modulation of the transmit-
ter.
AF peak indication (SK 100 G2 only)
The yellow LED (AF PEAK)
audio input level is excessively high (AF peak) and overmodulates the trans-
mitter. At the same time, the 7-step level display for audio signal "AF" shows
¿
full deflection for the duration of the overmodulation.
"PILOT" display
The "PILOT" display
pilot tone transmission is activated (see: „Activating/deactivating the pilot
tone transmission or pilot tone evaluation" on page 35).
Display backlighting (SK 100 G2 only)
After pressing a button, the display remains backlit for approx. 15 seconds.
The transmitter is switched on and the capacity of the
batteries/accupack BA 2015 is sufficient.
The batteries are/the accupack BA 2015 is going flat (LOW
BAT)!
capacity approx. 100 %
capacity approx. 70 %
capacity approx. 30 %
LOW BAT
appears on the display panel when the transmitter is
at the front of the SK 100 G2 lights up when the
lights up when the transmitter display panel if the
on the display panel provides
13