Table of Contents
Advertisement
TRUE
tdc
INSTALLATION OF CASTORS OR
OPTIONAL LEGS
Important Safeguard for installation of leg/castor. Images 1-5 demon-
strate procedure.
REMOVING KICKPLATE:
Before installing optional legs or castors the kickplate at the bottom
of the unit will need to be removed. To remove kickplate first remove
any loose items from inside the unit (shelving, baskets, etc). Then
remove the top plastic lid which you gain access to the inside of the
unit. Lay the unit on it's side. Make sure the unit is on soft packing
material so not to scratch the cabinet. Then backout 1/4" hex head
screws all around the base of the unit. (See illustration 1 and image
1). After the kickplate has been removed reinstall all of the hex head
screws back into the base of the unit. (See image 2). Castors and legs
are to be installed in the corners of the base of the unit.
UNIT LEVELING WITH CASTORS:
Four leveling shims have been provided for leveling on uneven floors
when using optional castors. Shims must be positioned between the
base of the unit and bearing race (See image 3). TRUE recommends
a four shim limit to any single castor.
A. Turn the bearing race counter-clockwise until the cabinet is
level. Level front to back and side to side. (diagonally)
B.
Install the desired number of shims, making sure the slot of the
shim is in contact with the threaded stem of the castor.
C. If more than one shim is used, turn the slot at a 90° angle so
they are not in line.
D. Turn the bearing race clockwise to tighten and secure the
castor by tightening the anchoring bolt with a 3/4-inch open-
end wrench, socket, or the tool provided.
CAUTION: To avoid damage to lower rail assembly, slowly raise
unit to upright position after installing castors.
UNIT LEVELING WITH LEGS:
Turn the legs clockwise to tighten in each corner of the cabinet base.
(See image 4). After legs are secure level the unit by backing out the
end the leg shown in image
5. Turn the end of the leg
until the cabinet is level. Level
front to back and side to side
(diagonally).
Illustration 1.
1
Removing kickplate
3a
Installing castors (shims)
4
Installing legs
Lower Rail
Assembly
Rail End
Snug Fit
Here
Leveling Shim
Leg
.
www
truemfg
2
For leveling, insert the shim between
castor and frame rail.
3b
Installing castors (shims)
5
Leveling legs
Lower Rail Assembly
Rail End
Castor
.
com
Snug Fit
Here
Bearing
Race
6
Advertisement
Table of Contents
