Table of Contents
Advertisement
TRUE
tdc
GENERAL MAINTENANCE
MAINTENANCE CLEANING
CLEANING: Before cleaning out the interior locate the drain hose
in the rear grill area and be prepared to open the line and drain the
water into a pan or floor drain.
The lid can be removed from the cabinet. (See image 1). If the lid has
been removed, wash it with nonabrasive soap or detergent and water.
Use the bare hand to feel and dislodge any caked soil.
Rinse thoroughly with clean water. Do not use hard, rough cloths that
will scratch the surface of the lid.
Dry with a clean, damp chamois. The interior can be cleaned but,
before doing so make sure the drain at the bottom of the cabinet is
open and the drain hose in the rear grill is at a floor drain.
MAGNETIC ICE BREAKER:
Magnetic ice breaker were designed to provide a fast and effective
way to remove the frost from the wall above the product. Frost
accumulation reduces the refrigeration effectiveness as it increases
in thickness.
The frequency at which to clean the ice breaker is a function of the
store operation as a starting point.
Thaw and clean at the beginning of each day. Thaw under warm
water or on a counter top at room temperature until ice breaker
is flexible and clear of frost. Wipe dry to prevent returning moisture
to cabinet.
NOTE: Magnetic ice breakers are soft and flexible at room temper-
ature but, they will become relatively rigid when they have been
exposed to low temperature from the cabinet.
DO NOT FOLD MAGNETIC ICE BREAKERS! Reinstall
the ice breakers by forming around corners. The ice breakers are
magnetic and they will attach tightly to the wall and resist sliding
in place. To overcome this apply from one end and roll into place.
(See image 3).
1
Hinge Bracket
The lid can be removed by lifting it
out of the hinge bracket.
3
Magnetic Frost Shield
LIGHT BULB REPLACEMENT
When replacing the light bulb make sure the light switch is turned
off. (See image 1).
•
Hold firmly on the end of the light bulb and pull toward the center
of the cabinet. The lampholders are spring activated so the bulb
can easily be replaced. (See image 2).
•
When installing a new bulb make sure the prongs at the end of
the bulb seat appropriately into the lampholder.
Light Switch
1
Light Bulb
3
FOR ADDITIONAL MAINTENANCE INSTRUCTION,
PLEASE VISIT THE MEDIA CENTER AT
WWW.TRUEMFG.COM
.
.
www
truemfg
com
2
18
Advertisement
Table of Contents
