RUGGEDCOM RSG2488F
Installation Guide
NOTE
Power modules are hot swappable. When installing/removing a power module, it is not necessary to
turn off power to the device.
Removing a Power Module
To remove a power module, do the following:
1.
Loosen the screws that secure the module to the chassis until the module can be removed.
1
Figure 21: Removing a Power Supply
1. Screws 2. Power Supply 3. Chassis
2.
Slide the module out of the chassis.
3.
Install a new or blank module to prevent the ingress of dust and dirt.
Installing a Power Module
To install a power module, do the following:
1.
If equipped, remove the existing module.
2.
Insert the module into the empty slot.
Installing/Removing Power Modules
2
3
Chapter 4
Modules
33