Main/Sub And Address Setting For Wireless Remote Controller For Fdmq Series - Daikin RX-W Series Service Manual

Field Settings for FDMQ, FFQ Series
5.5 MAIN/SUB and Address Setting for Wireless Remote
Controller for FDMQ Series
Outline
 If setting multiple wireless remote controllers to operate in one room, perform address setting
 If using both a wired remote controller and a wireless remote controller with 1 indoor unit,
Signal Receiver
PCB Setting
MAIN/SUB switch
Set the MAIN/SUB setting switch (SS1) on the signal receiver PCB to SUB.
MAIN/SUB setting
switch (SS1)
Wireless address switch
Set the address setting switch (SS2) on the signal receiver PCB according to the table below.
Address setting
switch (SS2)
220
for the receiver and the wireless remote controller.
change the MAIN/SUB switch of the signal receiver PCB.
Address setting switch (SS2)
Setting the receiver
(lt is factory set to "1")
MAIN/SUB setting switch (SS1)
MAIN
M
S
R7000181
No.1 No.2
1
1
2
2
3
3
R7000183 R7000184
(R24951)
SUB
M
S
R7000182
No.3
1
2
3
R7000185
Part 7 Trial Operation and Field Settings
SiUS092230EA