Brother PJ-600 Series Command Reference Manual page 28

Name Set paper width
Syntax ESC +
1B H + 7E H + 77 H + {n1} + {n2}
Description Specifies the paper width.
※The selection method is different for custom paper and for non-custom paper.
■Non-custom paper
The units of the data are in bytes.
Example: For A4, the number of dots for the print area is 2400, so 300 is set.
Ex. 1B H 7E H 77 H 2C H 01 H
→A4 setting (300)
■Custom paper
Specify the width according to the feed position, as shown below.
With [Center Alignment]
Specify, in bytes, the number of dots for the width of the print area.
Example: For a 140-mm-wide print area, the number of dots for the print area is 1654, so
207 is set.
Ex.1BH 7EH 77H CFH 00H
With [Left Alignment]
Specify as fixed, regardless of the paper width, as shown below.
300dpi： 1BH 7EH 77H 34H 01H
200dpi： 1BH 7EH 77H CCH 00H
Name Set paper length
Syntax ESC +
1B H + 7E H + 6C H + {n1} + {n2}
Description Specifies the paper length.
Normally used with roll paper or custom lengths.
The setting range is 200 to 65535 (raster lines).
Ex. 1B h 7E H 6C H E4 H 0C H
→The length of the print area is set to 3300.
Name Set left margin
Syntax ESC +
1B H + 7E H + 24 H + {n1} + {n2}
© 2015 Brother Industries, Ltd. All Rights Reserved.
Brother PJ-600/700/800 Series Command Reference 25
~ + w + {n1} + {n2}
~ + l + {n1} + {n2}
~ + $ + {n1} + {n2}