Follett 7/15 Series Sparkling - Installation Checklist
Before beginning:
Separate boxes for dispenser, carbonator, installation kit, and accessories.
Customer-supplied, beverage-grade CO
Assemble system:
Sparkling water, still water, and power cord installed between carbonator and
dispenser.
Water block ood protection device set to "2" and installed vertically after tee on the
water line to the carbonator water inlet.
ShockBlok water pressure regulator installed after water block and before carbonator
water inlet.
CO
regulator set to 60 psi.
2
Turn on water, plug in dispenser – leave carbonator and CO
No leaks in plumbing connections. Check before reinstalling dispenser side panel.
Carbonator air is bled according to installation instructions.
Turn on carbonator and CO
Sparkling and still water ow from correct button press.
Carbonator pump cycles on and off between sparkling water dispenses.
Perform 4 separate 16 oz sparkling water dispenses.
Notes:
Allow carbonator pump to cycle off between dispenses.
Do not exceed 32 oz continuous sparkling dispense.
Allow at least 1 hour for chiller to reach optimal temperature.
2
Sparkling Water and Ice Dispenser 7CI100A/7FS100A, 15CI100A/15FS100A
:
2
cylinder is present and full.
2
off:
2