Wds Mode - D-Link NUCLIAS CONNECT DAP-2610 Manual

D-Link DAP-2610 User Manual

WDS Mode

Wireless Band: Select either 2.4GHz or 5GHz from the drop-down
menu.
Mode: WDS is selected from the drop-down menu.
Network Name (SSID): Service Set Identifier (SSID) is the name designated
for a specific wireless local area network (WLAN). The
SSID's factory default setting is dlink. The SSID can
be easily changed to connect to an existing wireless
network or to establish a new wireless network.
Auto Channel Selection: Enabling this feature automatically selects
the channel that will provide the best wireless
performance. This feature is not supported in WDS
mode.
Channel: All devices on the network must share the same
channel. To change the channel, use the drop-down
menu to make the desired selection.
Channel Width: Click the drop-down menu to select 20 MHz, Auto
20/40 MHz or Auto 20/40/80 MHz. Select 20 MHz
if you are not using any 802.11n wireless clients.
Auto 20/40 MHz allows you to connect to both
802.11n and 802.11b/g or 802.11a wireless devices
on your network.
AP MAC Address:
Enter the MAC addresses of the root AP of this WDS
network. If left empty, then this device is the root AP.
16