Table of Contents
Advertisement
4-3. Setting the pedal
When you use the cassette clamp, it is possible to select 2-pedal unit or 3-pedal unit.
Set the memory switch as described below according to the pedal to be used.
memory switch
U081
When the feeding frame control is carried out
normally
Operation sequence of the feeding frame is
set by operating the pedal
U082
When the feeding frame control is stopped in
the middle
Operation sequence of the feeding frame is
set by operating the pedal
Carry out the following settings depending on your needs.
Refer to the Engineer's Manual for how to change the memory switch Kxxx (level 2).
memory switch
K194
One-touch utility cassette clamp mode
K195
One-touch utility cassette clamp, feeding
frame delay time
When the 2-pedal unit is used or when the K194
is set to "Automatic", this memory switch is used
for setting the time lapse after the cassette is
clamped before the feeding frame comes down.
K196
One-touch utility cassette clamp, auxiliary
presser delay time
Item name
Table 3: Setting the pedal
Item name
Table 3: Detailed setting of the pedal
– 11 –
Set value
two-pedal
0
0
Set value
Manual (feeding frame switch)
→The feeding frame comes down with the
pedal switch.C125Automatic (clamp sensor)
Automatic (clamp sensor)
→After the cassette is clamped, the feeding
frame automatically comes down.C128
Range: 0 to 5000 (msec)
Editing unit: 10 (msec)
Default value: 500 (msec)
Range: 0 to 5000 (msec)
Editing unit: 10 (msec)
Default value: 500 (msec)
Three-pedal
2
2
Advertisement
Table of Contents
