List Of Functions - Roland CAMM-1 PRO User Manual

7-3 List of Functions

Control-key Functions
This describes the functions of the control keys when pressed.
Key
PRESET This calls up user-set cutting conditions matched to the
tool and material in use.
FORCE This sets the force for the blade during cutting.
Perform a cutting test and set the conditions to match
the loaded material and the installed blade.
SPEED This sets the speed for the blade during cutting.
Perform a cutting test and set the conditions to match
the loaded material and the installed blade.
CURSOR These move the material and the carriage.
[ ] [ ] [ ] [ ] When a menu is displayed, these change the menu
items and setting values.
PAUSE This pauses cutting. The PAUSE LED lights up while
operation is paused. Pressing this a second time
cancels the paused state. To quit cutting, hold down
[ENTER] for 0.5 seconds or longer.
This key is also effective when performing material
feed using the [AREA MOVE] menu.
MENU This enters the menu mode.
In the menu mode, use the [
to the next menu, the [
screen, and the [
screen.
ENTER This enables, runs, or stores the item shown on the
display.
ORIGIN Holding down this key for 0.5 seconds or longer sets
the origin point at the present blade position (the blade
center).
SHEET CUT Holding down this key for 0.5 seconds or longer cuts
off the material at the present position of the separating
knife. Press this to sever an already-cut piece of
material from a roll of material. Severing cannot be
performed while cutting is in progress.
TEST CUT Holding down this key for 0.5 seconds or longer
performs a cutting test at the present blade position.
For more information, see "4-3 Adjusting the Blade
Force and Cutting Speed."
MENU + Power on This sets the language for messages on the display.
(LANGUAGE) You can select from among seven languages:
Japanese, English, Portuguese, Italian, Spanish,
French, and German.
Power on This selects the type of material to use and enables the
(SELECT SHEET) setup state. For more information, see "5-2 Details of
the Origin-point Location and Cutting Area."
46
All manuals and user guides at all-guides.com
Function
] and [
] key to move to the setting
] key to move to the previous
Range
Preset 1 to 8
20 to 350gf
(10gf step)
1 to 85 cm/s
(1 cm/s step)
–
–
–
] keys to move
–
–
–
–
/ ENGLISH/
PORTUG / ITALIANO/
ESPAÑOL / FRANÇE/
Deutsch
ROLL/PIECE/
F-EDGE/R-EDGE
Default
–
50gf
50 cm/s
–
–
–
–
–
–
–
ENGLISH
–