Wand Audio/Video Settings - Nintendo Wii Operation Manual

TV and Audio/Video Settings
After you have completed all steps of the setup procedure and are ready to
use the Wii system, you will need to set the appropriate "input select"
setting for your TV, VCR or other audio equipment.
1. Turn ON the power for yourN and any audio equipment connected to your
gameplay setup and the power on the Wii console.
2. Select the correct input setting for yourTV(see Input Select Information at right).
3. The Wii Menu (see below) should appear on the TV screen. See the Wii Menu
section of the Operations Manual - Channels and Settings, for more information on
this feature.
If the Wii Menu screen does not appear, check to make sure your input setting is
correct and review the Troubleshooting section on pages 33-34.
18
Input Select Information
The input select allows you to switch between the different inputs on yourN orVCR.
Manufacturers of TVs and VCRs use different names and locations for "input select."
The common names for the input select are: input, select, input select, line, line in,
source, in, EXT, and AUX. Consult yourN or VCR instruction manual for details.
NOTE: More information on "Input Select" is available on our web site at
support.nintendo.comlconsumerlinputselects.html
Locate the input select for the component that the Wii AV Cable is connected to (either
the TV or VCR). The most common locations for input select are:
•A button on the front of the TV or VCR.
•A button on the remote control.
•A high-numbered or low numbered channel (92, 99, 00, or 02) on the TV orVCR.
•An on-screen menu selection.