Nintendo Wii Operation Manual page 18

* Using the Sensor Bar Stand
Communication between the Wii Remote and the Sensor Bar may be improved in some situations by mounting the Sensor Bar on the Sensor Bar stand; for example, if the TV is
sitting on the floor.
1. Remove the protective film from the foam pads
2. For additional stability, you can add adhesive backed foam tape from the supplied sheet. These can be applied
on the bottom of the Sensor Bar stand. to both the top and bottom of the stand.
3. If you are using the extra foam tape, 4. Attach the Sensor Bar stand to the Sensor Bar, aligning the pegs
remove the protective film from the on the stand with the holes in the bottom of the Sensor Bar.
piece on the top of the Sensor Bar stand.
5. Mount the Sensor Bar stand to:
• the front edge of the surface the TV is sitting on, or
• tothetopoftheTV.
Do not place the Sensor Bar stand below the
surface that the N is sitting on; for example, on
shelves below the N.
Be sure to:
• Align the center of the Sensor Bar with the center of the N.
• Align the front of the Sensor Bar with the front edge of the N, or with the front edge of the surface that the N is sitting on.
16
I