Table of Contents
Advertisement
SMCWUSBT-G2 Utility
To set up the WEP function, take the following steps:
1. Select 64-bit encryption, 64-bit encryption (ASCII), 128-bit
encryption,or 128-bit encryption (ASCII) in the Key Type field.
2. To automatically generate keys, check the Use Passphrase
box, and type in a string of characters in this field.
3. In the Default Key field, select one key as the default key that
you want to use for encryption.
4. Click Apply Change to allow the settings to take effect.
Or
1. Select 64-bit encryption, 64-bit encryption (ASCII), 128-bit
encryption,or 128-bit encryption (ASCII) in the Key Type field.
2. In the Default Key field, select one key as the default key that
you want to use for encryption.
3. Manually type in a string of characters in the corresponding
key number field that you selected in step 2.
4. Click Apply Change to allow the settings to take effect.
Note:
When setting up WEP without using the Use Passphrase
function, if the Key Type is set to Hex, only Hexadecimal
characters (range: 0~9 and A~F) can be used. When
encryption is set to 64-bit, a maximum of 10 Hex characters
can be entered in the Key field. When encryption is set to
128-bit, a maximum of 26 Hex characters can be used. If the
Key Type is set to ASCII, and encryption is set to 64-bit, then 5
ASCII characters can be used in the Key field. For 128-bit
encryption, 13 ASCII characters can be used.
22
Advertisement
Table of Contents
