Advertisement
BACK - Barricade Plus PPTP Server
NEXT – Glossary
SECTION 5: Barricade Plus IPSec Tunnel Configuration
IMPORTANT NOTE: When setting up a VPN connection, your local LAN and the remote
network must be on different subnets (i.e. – If the remote gateway/router has a LAN IP
of 192.168.1.1, your Barricade Plus should be set to 192.168.x.1 where X is equal to a
number between 2 and 254)
Step 1: Open up your web browser and type in the IP Address of your Barricade Plus.
Step 2: Enter your password to log into the router and then go into the Advanced
Setup.
Step 3: Click on the link for VPN on the left. Then click IPSec.
Step 4: The Barricade Plus supports a maximum of 3 IPSec tunnels. These tunnels can
be established to different gateways/routers simultaneously.
(For example: Four companies in different physical locations could connect their
networks using IPSec with four Barricade Plus routers at the front of each network. Each
individual router would simply have their 3 tunnels configured to connect to the other
three routers.)
Advertisement
