Advertisement
BACK - Barricade Plus PPTP Client
NEXT – Barricade Plus IPSec Tunnels
SECTION 4: Configuring the Barricade Plus as a PPTP Server
IMPORTANT NOTE: When setting up a VPN connection, your local LAN and the remote
network must be on different subnets (i.e. – If the remote gateway/router has a LAN IP
of 192.168.1.1, your Barricade Plus should be set to 192.168.x.1 where X is equal to a
number between 2 and 254)
Step 1: Open up your web browser and type in the IP Address of your Barricade Plus.
Step 2: Enter your password to log into the router and then go into the Advanced
Setup.
Step 3: Click on the link for VPN on the left. Then click PPTP.
Step 4: The router allows you to configure up to 20 different PPTP VPN accounts. Click
the [Edit] link for the first account and then you will be able to configure the appropriate
IP Addresses.
Figure 1.0
Step 5: Enter the necessary data. This information is used to establish a Point-to-Point
Advertisement
