Telnet Settings - SMC Networks TigerSwitch SMC6128L2 Management Manual

C
ONFIGURING THE
CLI – Enter Line Configuration mode for the console, then specify the
connection parameters as required. To display the current console port
settings, use the show line command from the Normal Exec level.
Console(config)#line console
Console(config-line)#login local
Console(config-line)#password 0 secret
Console(config-line)#timeout login response 0
Console(config-line)#exec-timeout 0
Console(config-line)#password-thresh 3
Console(config-line)#silent-time 60
Console(config-line)#databits 8
Console(config-line)#parity none
Console(config-line)#speed 9600
Console(config-line)#stopbits 1
Console(config-line)#end
Console#show line
Console configuration:
Password threshold:
Interactive timeout: Disabled
Login timeout:
Silent time:
Baudrate:
Databits:
Parity:
Stopbits:
VTY configuration:
Password threshold:
Interactive timeout: 600 sec
Login timeout:
Console#

Telnet Settings

You can access the onboard configuration program over the network using
Telnet (i.e., a virtual terminal). Management access via Telnet can be
enabled/disabled and other various parameters set, including the TCP port
number, timeouts, and a password. These parameters can be configured
via the web or CLI interface.
Command Attributes
• Telnet Status – Enables or disables Telnet access to the switch.
(Default: Enabled)
• Telnet Port Number – Sets the TCP port number for Telnet on the
switch. (Default: 23)
3-32
S
WITCH
3 times
Disabled
60
9600
8
none
1
3 times
300 sec
4-15
4-16
4-17
4-18
4-19
4-20
4-21
4-21
4-22
4-23
4-24
4-25