1000Base-T Pin Assignments - SMC Networks SMC6824M Installation Manual

1000BASE-T Pin Assignments

1000BASE-T ports switch support automatic MDI/MDI-X operation, so
you can use straight-through cables for all network connections to PCs or
servers, or to other switches or hubs.
The table below shows the 1000BASE-T MDI and MDI-X port pinouts.
These ports require that all four pairs of wires be connected. Note that for
1000BASE-T operation, all four pairs of wires are used for both transmit
and receive.
Use 100-ohm Category 5 or 5e unshielded twisted-pair (UTP) or shielded
twisted-pair (STP) cable for 1000BASE-T connections. Also be sure that
the length of any twisted-pair connection does not exceed 100 meters (328
feet).
Pin
1
2
3
4
5
6
7
8
T
MDI Signal Name
Transmit Data plus (TD1+)
Receive Data minus (RD1-)
Transmit Data plus (TD2+)
Transmit Data plus (TD3+)
Receive Data minus (RD3-)
Receive Data minus (RD2-)
Transmit Data plus (TD4+)
Receive Data minus (RD4-)
-P C
WISTED AIR ABLE AND
MDI-X Signal Name
Transmit Data plus (TD2 +)
Receive Data minus (RD2-)
Transmit Data plus (TD1+)
Transmit Data plus (TD4+)
Receive Data minus (RD4-)
Receive Data minus (RD1-)
Transmit Data plus (TD3+)
Receive Data minus (RD3-)
P A
IN SSIGNMENTS
B-5