Table of Contents
Advertisement
M
N
AKING
ETWORK
MDI-X port using straight-through cable. To connect between two
switches/hubs that only have fixed MDI-X ports, the wiring crossover
must be implemented in the cable - known as a crossover cable.
The RJ-45 ports on the switch base unit support automatic MDI/MDI-X
operation, which means that they automatically detect the wiring in the link
and configure as MDI or MDI-X accordingly. So for these ports, you can
use standard straight-through twisted-pair cables to connect to any other
network device (PCs, servers, switches, hubs, or routers). However, note
that auto-negotiation must be enabled on these ports for automatic wiring
configuration to function properly.
See Appendix B for further information on cabling.
Connecting to PCs, Servers, Hubs and Switches.
Caution: Do not plug a phone jack connector into an RJ-45 port.
This will damage the switch. Use only twisted-pair cables with
RJ-45 connectors that conform to FCC standards.
1. Attach one end of a twisted-pair cable segment to the device's RJ-45
connector.
4-2
C
ONNECTIONS
Figure 4-1. Making Twisted-Pair Connections
Advertisement
Table of Contents
