Table of Contents
Advertisement
CLEANING & MAINTENANCE
The shaver is a wet/dry appliance. The shaver may be cleaned under warm
water.
NOTE: **When cleaning your shaver, make sure the shaver is turned off and
disconnected from the power cord.**
CAUTION!
•
To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
detergents or other chemicals.
•
To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or
heater to dry the shaver.
NOTE: Lubricate cutters after rinsing.
CLEANING YOUR SHAVER
NOTE: We recommend following these steps after each use.
F
1.
Remove the foil assembly by pressing the release buttons on both sides of the
head and lifting the foil assembly upwards to remove from the hair pocket.
(Diagram F)
2.
Tap out excess hair shavings.
3.
Rinse the head of the assembly under running water. (Diagram G)
4.
Replace the head assembly by placing the assembly on top of the hair pocket,
press down and click into place. (Diagram H)
NOTE: Lubricate teeth of trimmer with oil every six months.
This product conforms to radio frequency interference requirements
Any product purchased and used commercially carries a limited 90 Day Warranty.
G
Suitable for use in bath and shower.
10
H
Advertisement
Table of Contents
