Table of Contents
Advertisement
U
SING THE
L
OADING THE
1.
Open the paper separator all the way.
2.
Remove the paper roller.
Note that there is a disk on the left end of the roller.
3.
Slide the roller into a tube of paper.
Ensure the disk is on the left side and paper must roll up from
the bottom.
4.
Replace the paper roller back into the stand, with the disc
on the left side.
5.
Feed the paper over the roller on the stand. NOT UNDER!
6.
Adjust the round paper guides at either side to the paper
width.
7.
Feed the paper down behind the platen and use platen
knob to bring paper through the printer.
Lift the bail arm as paper comes round to front of platen. (The
paper release lever needs to be in the top position to perform
this step).
R
P
OLL
APER
P
APER
OPERATING YOUR PRINTER > 33
S
(
TAND
IF FITTED
)
Advertisement
Table of Contents
