Location; Water Supply Connection; Electrical Connection - Henny Penny HCH-930 CDT Operator's Manual

2-3. LOCATION

2-4. WATER SUPPLY
CONNECTION

2-5. ELECTRICAL CONNECTION

Model
Number Volts
HCH-930/932 120
HCH-930/932 240
HCH-930/932 230
2-2
The unit should be placed on a table or shelf to allow easy access
for loading and unloading of product. For proper operation, the
cabinet must be level.
The automatic water fill system requires a cold water supply.
The unit has a water strainer and fittings for connections to 1/4"
(6.35 mm) copper tubing. Run 1/4" (6.35 mm) copper tubing to
the cabinet, providing extra tubing to allow movement of the unit for
cleaning or maintenance. A water conditioner or filter is recom-
mended. Install a shut-off valve in the supply line.
Follow these steps when making the water supply connection:
1. Flush the incoming water line.
2. Insert the 1/4" (6.35 mm) copper tubing into the compression
nut and ferrule as far as it will go.
3. Tighten the nut with a 7/16" wrench.
Do not operate the unit without water connected to the
unit, or damage to components may result.
This unit as manufactured requires the installation of an appro-
priate back-siphoning device (as per National Plumbing Code
ASA-A40:8-1955) to be connected to the water inlet line.
This device to be connected in accordance with basic plumbing
code of the Building Officials and Code Administrators Interna-
tional, Inc. (BOCA), and the Food Service Sanitation Manual
of the Food and Drug Administration (FDA).
The heated holding cabinet is available from the factory as a
120 VAC, 50/60 Hz, 240 VAC, 50/60 Hz, or 230 VAC, 50 Hz,
single-phase unit. The data plate on the back of the unit specifies
Watts Amps
the correct electrical supply. The unit requires a grounded recep-
842 7.3
tacle with a separate electrical line protected by a fuse or circuit
842 3.5
breaker of the proper rating.
770 3.3
To avoid electrical shock, the cabinet must be
adequately and safely grounded (earthed) according to
local electrical codes.
(FOR EQUIPMENT WITH CE MARK ONLY!)
To prevent electric shock hazard this appliance must be
bonded to other appliances or touchable metal surfaces
in close proximity to this appliance with an
equipotential bonding conductor. This appliance is
equipped with an equipotential lug for this purpose.
The equipotential lug is marked with the following
symbol
Model HCH-930/932
207