Table of Contents
Advertisement
Installing Add-on Cards (Figure 6-14)
1. Disconnect the power supply, lay the chassis on a flat surface, and open the
chassis cover.
2. Pull open the add-on card slot clip in the rear of the chassis.
3. Slide the temporary PCI slot shield toward the slot clip and remove the
temporary shield from the chassis (see Figure 6-13).
4. Connect the add-on card to the riser card.
5. Secure the riser card to the motherboard tray using the riser card screw.
6. Slide the add-on card bracket into the rear add-on card slot and secure with
the add-on card bracket screws.
7. Close the add-on card slot clip.
Note: Under normal circumstances, the riser card and add-on card bracket are
not separated.
Figure 6-14. Installing the Low Profile Add-On Card
Add-on Card
Bracket
Add-on Card
Bracket Screws
Note: The motherboard node drawer is an example only, actual layout differs slightly
Note: The motherboard node drawer only accepts add-on cards up to 5.9"
(149,86 mm) in length.
Add-on Card
PCI Slot
Shield
6-15
Chapter 6: Advanced Chassis Setup
Riser Card
Screw
Riser Card
Advertisement
Table of Contents
