Setting The Time Program Efficiently; Deleting Time Phases - Viessmann VITOCROSSAL 300 CU3A 35 Operating Instructions Manual

Vitocrossal 300 CU3A 26 to 199 Operating
Time Program
(continued)

Setting the time program efficiently

If you would like to set a different time program for just
one day of the week, proceed as follows:
Example: You want to set a different time program for
Monday:
1. Select the period "Monday–Sunday" and set the
time program.
Note: The check mark is always set at the sections of
the week with identical time phases.
Factory setting: Same for all days of the week,
therefore "Monday-Sunday" is checked.
2. Then select "Monday" and adjust the time program
for that day.
Note: The "Saturday-Sunday" part of the week is
checked because the set time phases correspond
only to this part of the week.

Deleting time phases

H Set the time for the end point to the same time that
was set for the start point.
Or
H For the start point, select a time prior to 00:00 h.
The display shows the selected time phase as
"- - : - -".
Operation
19