Table of Contents
Advertisement
3-10 When Cutting is Completed
When not in use for extended
periods, unplug the power cord from
the electrical outlet.
Failure to do so may
result in danger of
shock, electrocution,
or fire due to
deterioration of the
electrical insulation.
NOTICE
Do not leave the tool mounting screws tightened. Tightening the screw makes it more difficult to install the
blade holder.
1
Press the SETUP key. Hold down for about 1 sec.
The SETUP LED goes out and the cutting carriage
moves to the right edge of the cutting area.
SETUP LED goes out
3
(2) Remove the blade holder from the cutting carriage.
(1) Loosen the tool
securing screw on
the cutting carriage.
5
Turn off the power.
All manuals and user guides at all-guides.com
Cutting carriage
Tool securing screw
2
Raise the sheet loading lever, then remove the
material.
Material
4
Press the push-pin and remove the blade from the
blade holder.
If a blade was used, wipe the blade with a soft cloth to
remove any material that may cling to it.
Blade holder
Blade
POWER/ERROR LED goes out
Use a soft, dry cloth to wipe down the CM-24/12.
Sheet loading lever
Press the push-pin
19
Advertisement
Table of Contents
