Table of Contents
Advertisement
Material Loading Position
CM-24
CM-12
- If you are using roll material, start with step 1.
- If you are using piece material, start with step 2.
If you are using the CM-24, set DIP switch SW-9 to OFF (roll) when roll material is loaded, or to ON (piece) when flat (piece)
material is loaded. Be sure the power to the CM-24 is off when changing the DIP switch setting.
(On the CM-12, SW-9 is not used. This switch should always be set to "OFF.")
1
Raise the sheet loading lever.
Pass the end of the material between the pinch rollers and the grit rollers so that it extends from the front of the unit.
[If You Are Using the Roller Base]
Pull out the length
of material that is to
be cut from the roll.
Roller base
* If you are using the CM-12, use a substitute of the
roller base to secure the rolled material in place.
All manuals and user guides at all-guides.com
6"
(approx. 152 mm)
12"
(approx. 305 mm)
Position of the pinch roller
Position of the pinch roller
(right) for material with
(right) for material with
a width of 12"
a width of 6"
Position of the pinch roller
Position of the pinch roller
(right) for material with
(right) for material with
a width of 6"
a width of 12"
16" (approx. 406 mm)
The left-hand pinch roller can be moved within this range.
When loading material with a width other than one indicated above,
move the left-hand pinch roller.
[If You Are Not Using the Roller Base]
: Grit roller
: Pinch roller (left)
18"
(approx. 457 mm)
(approx. 610 mm)
Position of the pinch roller
(right) for material with
a width of 18"
*Do not set the pinch roller here.
28" (approx. 711 mm)
*Do not set the pinch roller here.
Do not load the material as shown
in the figure, because correct
Cut off the length of
material feed will be impossible.
material that is to
be cut from the roll.
: Pinch roller (right)
Material
24"
Position of the pinch roller
(right) for material with
a width of 24"
Not OK
11
Advertisement
Table of Contents
