Table of Contents
Advertisement
3-8 Downloading Cutting Data
NOTICE
When loading a flat material the CM-12 that has been cut, be sure to use a flat material that is about 100 mm
(3-15/16") longer than the vertical size of the cutting data. If data larger than the vertical length of the material
is sent, the CM-12 will attempt to cut the data even if it does not all fit in the material. This means that the
material is dislodged from the grit roller, and cutting continues with no material. This can cause not only
breakage to the blade but also damage to the unit, and adequate care is required to prevent this.
If the material becomes dislodged, immediately press the PAUSE key or turn off the power switch.
The unit will begin cutting when it receives cutting data sent from the computer.
For information on how to install the CAMM-1 DRIVER for Windows
(This "Readme.txt" file is located on the corresponding disk.)
Pausing Cutting Operations
If you wish to pause operation while cutting is in progress, follow the steps described below.
Press and hold the PAUSE key until the PAUSE LED lights up.
Cutting is paused.
The PAUSE LED lights up
[To Resume Cutting]
Press the PAUSE key.
Cutting is resumes.
The PAUSE LED goes out
Continuing Cutting
[Cutting After Changing the Material]
Follow the procedure described from "3-5 Loading the
Material" to "3-8 Downloading Cutting Data" .
* If the same type of material is used, then a cutting test is
not necessary.
All manuals and user guides at all-guides.com
®
95, please refer to the "Readme.txt" file.
[To Terminate Cutting]
(1) Halt transmission of cutting instructions from the com-
puter.
(2) Press the SETUP key. Hold down for about 1 sec.
The SETUP LED goes out
Cutting instructions already sent from the computer to the
CM-24/12 are deleted, the cutting carriage moves to the right,
and cutting stops.
[Continuing Cutting on the Same Material]
Refer to "3-6 Setting the Origin Point" and set the origin at a
place which has not yet been cut (i.e., at the place to be cut
next).
Then send cutting data from the computer to the CM-24/12.
17
Advertisement
Table of Contents
