Rear Panel; Sens Select Switch; Pedal Sw Jacks - Roland SPD-6 Owner's Manual

Rear Panel

fig.0-4
AC adaptor jack
When using the separately sold AC Adaptor BOSS PSA
series, connect it to this jack (p. 12).
[PEDAL SW] jacks
Pedal switches (sold separately: DP-2) or foot switches
(sold separately: BOSS FS-5U) can be connected here to
play sounds (p. 15).
[VOLUME] knob
This knob adjusts the volume of the SPD-6's internal
sounds (p. 17).
[OUTPUT] 1 (PHONES)/2 (MONO) jacks
These jacks output the internal sounds of the SPD-6,
and are for connection to external audio devices or
amps (p. 14).
If using a single cable for monaural output, you must
use the "2 (MONO)" jack.
If using headphones, connect them to the "1
(PHONES)" jack (p. 14). When you use headphones, do
not connect anything to the "2 (MONO)" jack.
* The internal sounds of the SPD-6 will be output in monaural.
MIDI OUT connector
Connect a MIDI cable to this connector when making
connections to an external MIDI device (p. 26).
Parts of the SPD-6 and Their Function
[SENS] select switch
This sets the sensitivity of the pads, as you may play
with sticks or your hand (p. 18). For hands, set this to
the position. For drumsticks, set this to the
position.
MicroSaver Security Slot (
MicroSaver and Kensington are registered trademarks
of Kensington Microware Limited.
© 1997 Kensington Microware Limited
Kensington Microware Limited
2855 Campus Drive
San Mateo, CA 94403 U.S.A.
Web:www.kensington.com
)
9