Soloing A Part - Roland Studio Canvas SD-80 Owner's Manual

■ Soloing a part

When multiple parts are sounding, you can cause only the currently selected part to sound, allowing you
to check the performance of that part. This is referred to as "soloing" the part.
fig.5-09
1.
Press [INST].
The button will light.
2.
Press [PART ] or [PART ] to select the part that you want to solo.
fig.5-09a
3.
Hold down [SHIFT] and press [PART ] to solo the part
you selected in step 2. Parts other than the soloed part
will not sound, nor will the bar graph be displayed.
Solo will be defeated when you press [SHIFT]+[PART ] once again.
Using the internal sound generator
1,4
2
3
29