Table of Contents
Advertisement
Installation
Electrical installation
If the machine is delivered from the factory
with a plug attached it can be connected to an
earthed wall socket. Otherwise, a permanent
connection using a multipolar circuit breaker
must be made by a qualifi ed professional.
Connection on delivery
• 400 V, 3-Phase, 10 A
• 50 Hz
• Heat output 2500 W
• Use a type A residual-current device.
NOTE!
Do not connect the machine to the mains
electricity supply by an extension lead.
Switch-over
The switchover must be performed by a
qualifi ed electrician.
See the section Settings.
Coin operation
The machine is prepared for coin operation.
Such installation must be carried out by a
qualifi ed professional. The installation requires
a connection cable to power the coin meter.
This connection cable can be ordered using the
factory art. no. 92 090 95.
The coin meter shall be able to short circuit two
signal lines for periods of up to 10 minutes. This
is to give the user time to load the machine,
choose a programme and start the programme
after putting the coins in.
"Insert coin" appears on the display when the
machine is started with the main power switch.
25
Advertisement
Table of Contents
