Table of Contents
Advertisement
LOADING, STORAGE AND PASSENGER COMPARTMENT
||
Installation
IMPORTANT
The safety grille must only be used in the
rear position (behind the rear seat) descri-
bed here.
Before first installing the safety grille, the
existing plastic roof mountings must be
replaced with steel roof mountings. Volvo rec-
ommends that replacing roof mountings is
performed at an authorised Volvo workshop or
retailer.
1.
Fold the rear seat's backrest forward.
2. Make sure that the safety grille is turned in
the right direction. Lift in the safety grille
through one of the rear side doors.
3
Installation instructions no. 31659257.
610
3.
Position the safety grille's brackets on the
roof mountings.
The next step is facilitated if two people
hold the safety grille in the right position.
4.
Insert the supplied screw and tighten
using the supplied 6 mm Allen key. Repeat
on the other side. Recommended tighten-
ing torque: 20 Nm (15 foot-pounds).
> Check that the safety grille is properly
fitted.
5. Restore the backrest to the upright posi-
tion.
For more information about the tools required
and methods for fitting/removal, see the
installation instructions
3
that were included
with the initial purchase.
IMPORTANT
The protective grille cannot be folded up or
down when a cargo cover is fitted.
Advertisement
Table of Contents
