Required Tools And Materials; Decommissioning And Disposal - Siemens RUGGEDCOM RS900 Installation Manual

RUGGEDCOM RS900
Installation Guide
POWER LED
ALARM LED
Console Port
RESET Button
Communication Ports
Failsafe Alarm Relay
Power Supply Terminal Blocks
Section 1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RS900:
AC power cord (16 AWG)
Multi-mode and/or single-mode fiber optic cables
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #6-32 screws
Section 1.4

Decommissioning and Disposal

Proper decomissioning and disposal of this device is important to prevent malicious users from obtaining
proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of service, either permanently or
for maintenance by a third-party, make sure it has been fully decommissioned.
For more information, refer to the associated User Guide.
Required Tools and Materials
Illuminates green when power is supplied to the device.
Illuminates red when an alarm condition exists.
The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to
Shuts down and restarts the device. For more information, refer to
the Device".
Communication ports in general receive and transmit data, as well as provide access to the
RUGGEDCOM ROS Web interface. For more information about the various ports available,
refer to Chapter 4, Communication
Latches to default state when a power disruption or other alarm condition occurs. For more
information, refer to:
• Section 2.5, "Connecting the Failsafe Alarm Relay"
• Section 5.2, "Failsafe Alarm Relay Specifications"
Pluggable terminal blocks for connecting one or more power sources. For more information,
refer to Section 2.6, "Connecting Power"
Tools/Materials
Section 3.1, "Connecting to the
Ports.
and Section 5.1, "Power Supply
For connecting power to the device.
For connecting the device to a LAN.
For connecting the device to a LAN.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Introduction
Device".
Section 3.3, "Resetting
Specifications".
Purpose
Chapter 1
3