Fuel Gauge; Trip Meter / Clock / Voltmeter - Yamaha LF250 Owner's Manual

2
km/h
(km)
mph
(mile)
knots
(mile)
3
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26714

Fuel gauge

Eight segments indicate the fuel level. When
all segments are showing, the fuel tank is full.
The fuel level reading can be inaccurate due
to the position of the sensor in the fuel tank
and the attitude of the boat in the water. Op-
eration with bow-up trim or continuous turn-
ing can give false readings.
Do not adjust the selector switch for fuel sen-
sor. Incorrectly setting the selector switch on
the gauge will give false readings. Consult
your Yamaha dealer on how to correctly set
the selector switch. NOTICE: Running out of
fuel can damage the engine.
EMU36072

Trip meter / Clock / Voltmeter

The display shows either the trip meter, the
clock, or the voltmeter.
Instruments and indicators
To change the display, press the "
1
(mode) button repeatedly until the indicator
on the face of the gauge points to "
meter), "
EMU26692
Trip meter
This gauge displays the distance the boat has
traveled since the gauge was last reset.
The trip distance is shown in kilometers or
miles depending upon the unit of measure-
ZMU07001
ment selected for the speedometer.
To reset the trip meter to zero, press the "
(set) and "
time.
The trip distance is kept in memory by battery
power. The stored data will be lost if the bat-
tery is disconnected.
ZMU07002
EMU26702
Clock
To set the clock:
1.
2.
3.
4.
[ECM01771]
5.
6.
" (clock), or "
" (mode) buttons at the same
YAMAHA
SPEED
TRIP TIME BATT
set
Be sure the gauge is in the "
mode.
Press the " " (set) button; the hour dis-
play will begin blinking.
Press the " " (mode) button until the
desired hour is displayed.
Press the " " (set) button again, the
minute display will begin blinking.
Press the " " (mode) button until the
desired minute is displayed.
Press the " " (set) button again to start
the clock.
" (trip
" (voltmeter).
km/h
knot
mph
km
mile
mode
ZMU07003
" (time)
37
"
"