Graco HVLP EDGE Gun 256855 Repair Manual page 4

Component Identification
D E
C
B
A
ID Component
A Siphon Cup
B Check Valve
C Air Cap
D Air Nozzle
E Fluid Needle
F Flow Control Knob
Pressure Relief Procedure
The spray gun cup is pressurized by the gun air supply.
To reduce the risk of serious injury from pressurized fluid
or accidental spray from gun, always turn off the air sup-
ply to the gun before removing the spray gun cup. Unplug
sprayer from outlet
4
F
G
J
K H
M
ti12771a
N
ID Component
G Trigger Slide
H Air Inlet
J ™
EasyGlide Trigger
K Latch
M Swivel Tube
N Strainer
Setup
Make sure sprayer is turned off and unplugged from
power source. Refer to your sprayer instruction manual
for spray setup.
Connect Gun to Siphon Cup
1. Attach air hose from sprayer to
inlet fitting of gun.
2. Fill cup 3/4 full. Install cover. Latch
the gun cup cover to secure it to
siphon cup.
Operation
Adjust Spray Pattern
1. Set air cap to position for spray pattern desired.
2. Verify trigger slide is in SPRAY position (E) and not
NEEDLE REMOVAL position (D).
D
Component Identification
ti12797a
ti12872a
ti12763a
E
ti12795a
313317K