Toro Groundsmaster 3500-G Operator's Manual page 54

Preparing the Engine
1. Drain the engine oil from the oil pan and replace the
drain plug.
2. Remove and discard the oil filter. Install a new oil filter.
3. Refill the oil pan with 3.3 L (3.5 US qt) of motor oil.
4. Start the engine and run it at idle speed for
approximately 2 minutes.
5. Stop the engine.
6. For storage over 30 days, prepare the fuel system as
follows:
•
Add a petroleum based stabilizer/conditioner to
fuel in the tank.
Follow the mixing instructions from stabilizer
manufacturer. Do not use an alcohol based
stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
•
Run the engine to distribute conditioned fuel
through the fuel system for approximately 5
minutes.
•
Stop the engine, allow it to cool, and drain the fuel
tank.
•
Restart the engine and run it until it stops.
•
Start and run the engine until it will not start again.
•
Dispose of fuel properly. Recycle as per local codes
Important: Do not store
stabilizer/conditioned fuel over 90 days
7. Remove the spark plugs and check their condition;
refer to Replacing the Spark Plugs (page
8. With the spark plugs removed from the engine, pour 2
tablespoons of engine oil into the spark plug hole.
9. Use the starter to crank the engine and distribute the
oil inside the cylinder.
10. Install the spark plugs and tighten to recommended
torque; refer to Replacing the Spark Plugs (page
Note: Do not install the wires on the spark plugs.
11. Check anti-freeze protection and add as needed for
expected minimum temperature in your area.
12. Secure all fuel system fittings.
13. Thoroughly clean and service the air cleaner assembly.
14. Seal the air cleaner inlet and the exhaust outlet with
weatherproof tape.
Preparing the Cutting Deck
If the cutting deck is separated from the traction unit for any
length of time, install a spindle plug in the top of the spindle
to protect the spindle from dust and water.
39).
39).
54