Table of Contents
Advertisement
OPERATING THE PRODUCT
This section describes how to activate your fire using either the manual controls or remote control.
MAINS SWITCH
The mains switch is located under the fuel bed on the module and controls the electricity to the appliance (Fig 23A).
Note: This switch must be in the 'ON' ( I ) position for each appliance to operate.
MANUAL CONTROLS
Manual controls are located on the cassette module under the fuel bed. There are also manual controls on the tethered
receiver unit which is fitted loose.
REMOTE CONTROL
The remote control is supplied with 2x CR2032 batteries already fitted. Pull both tabs from the rear cover to engage the
batteries (Fig 24) and allow remote operation.
Note: The tethered receiver must be fitted to the product for remote control operation.
PAIRING THE REMOTE CONTROL
The remote control has wireless Bluetooth technology and needs to be paired to the receiver. This can be done by
following the steps below.
1.
Press the rocker switch to the on (I) position.
2.
Press the
button on the Button Panel; the product will turn on.
3.
Press the
button on the Button Panel, the LED's will start to slowly blink on and off.
4.
Press the
button on the remote control; the product LEDs will flash quickly five times and the product will then
automatically switch off. The remote control is now paired to the product and can be used to switch it back on.
TO REPLACE THE BATTERIES
1.
Remove battery cover of the remote control using a Philips screwdriver (Fig 25).
2.
Correctly install two 3 Volt (CR2032 or similar) battery in the battery holder with the + side facing up .
3.
Secure the battery cover using the previously removed screw.
Batteries must be recycled or disposed of properly.
Check with your Local Authority or Retailer for recycling advice in your area .
Frequency band(s) this product operates in: 2.4GHz
Maximum radio-frequency power transmitter in the frequency band(s) this product operates in: 2.71dBm
GETTING THE DESIRED FLAME EFFECT
1.
Switch the appliance on by pressing the main switch to the on position and pressing the
start after 45seconds.
2.
Press the
and
to the changes you make.
Once you have made your adjustments to both the flame height and crackling sound, the appliance will keep these
settings even if you power off the appliance by either the on/standby button or by the main switch. The next time you
switch on the appliance, it will start up as normal, wait 45 seconds for the flames to start and then revert to the adjusted
settings.
NOZZLE INSERTS
Nozzle inserts have been supplied and fitted to the nozzle opening. These inserts are used to alter the profile of the
flame effect. These inserts can be removed if a different flame profile is preferred. In addition to these inserts, inserts for
blocking the flame in certain areas have also been supplied. To fit these inserts, remove the exisitng inserts that have
been supplied and fitted to the product. Break the blocking inserts into the required length. Snap the inserts into the
nozzle opening in the desired location. See Fig 26 for further details.
buttons to adjust the flame to your desired level. Please give the flame generator time to react
8
button. The flames will
Advertisement
Table of Contents
